Australian
Passing Flash Modification
How
to rewire the Aussie headlights to raise when flashing your highbeams.
This
project compliments the 'fog lamp' modification but can be implemented
solely because of appearance reasons.
I
originally decided to implement the 'fog lamp' modification as one of
my first changes to the lighting system. But whith this mod came the problem
that when I had the fog lamps on, how could I then flash any oncoming
vehicles? This is the solution which allows for the pop up headlights
to raise and all driving lights to illumintate on a stock probe. And in
my case, only the lights within the pop up headlight assembly.
There
is no re-wiring required for this mod other than inserting a power diode
within the lighting harness.
1 x 1N5408(3A 1000V) power diode is required for this mod.
At
this stage it is a good idea to either remove the battery connections
or use a cordless soldering iron to solder the diode into place.
Removing
the plastic cover beneath the steering column will allow you to isolate
the required connector. A single screw located near the lower left of
the plastic and the bonnet release piece will need to be removed.
Once
the Combination switch connector has been located which is blue in colour,
insert the power diode into the relevant location and solder into position.
Connector
circuit diagram pic |
|
|
|
Actual
picture of connector and diode in position |
|
|
|
NB:
Any adjustments or modifications carried out on your motor vehicle are
done so at your own risk and neither the owner of this website nor anyone
associated with it accepts any responsibility or shall be held liable
for any possible damage resulting either directly or indirectly from such
modifications and/or adjustments.
|